Notes On Dual Power Feed Setting; Notes On Active Directory; Notes On Ldap Over Ssl - Fujitsu M10 Product Notes

Table 2-4 Work to be performed after you add, remove, or replace a PCI expansion unit
for a PCI slot of SPARC M10 chassis for which the direct I/O function is enabled
(continued)
Maintenance environment
When a normal PCI expansion
unit(*1) is replaced by
stopping the PPAR
*1 Includes cases in which a link card, link cable, management cable, or link board is replaced.

Notes on dual power feed setting

The power supply unit of the SPARC M10 system is redundantly configured.
Enabling or disabling the dual power feed function with the setdualpowerfeed(8)
command does not affect the behavior of a redundantly configured system.
Therefore, when the display results of the showdualpowerfeed(8) and showhardconf
(8) commands, which are dependent on the setting of the setdualpowerfeed(8)
command, also fall under any of the following conditions, the behavior of the
redundantly configured system is not affected.
The showhardconf(8) command displays "Power_Supply_System: Dual;" when
■
the showdualpowerfeed(8) command displays "Dual power feed is enabled."
The showhardconf(8) command displays "Power_Supply_System: Single;" when
■
the showdualpowerfeed(8) command displays "Dual power feed is disabled."
The system administrator can use this setting function as a memo for determining
whether the power supply unit has a dual power feed configuration.

Notes on Active Directory

If Active Directory is enabled and you try login via telnet, inquiry to the second
■
and subsequent alternative servers may time out, causing the login to fail.
If the value set by the timeout operand of the setad(8) command is small, and you
■
log in to the XSCF, the user privilege may not be assigned to you. In this case,
increase the timeout setting value and try again.

Notes on LDAP over SSL

If the value set by the timeout operand of the setldapssl(8) command is small, and
you log in to the XSCF, the user privilege may not be assigned to you. In this case,
increase the timeout setting value and try again.
Domain configuration Reconstructing
Oracle VM Server
for SPARC config
factory-default Unnecessary
Guest domain exists. Unnecessary
Chapter 2 XCP 2240-Related Information
Setting OpenBoot
PROM environment
variables again
Unnecessary
Unnecessary
23