Fujitsu M10 Product Notes page 113

Table 3-11 Problems resolved in XCP 2220 (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x x x
140227-006
RTIF2- x
140227-007
RTIF2- x x x
140227-008
RTIF2- x x x
140310-001
RTIF2- x x x
140312-001
Description
If [Ctrl]+[C] is pressed when any of the
following command is running, in some
very rare cases, the command may not
terminate, moreover, other running
commands executed by other logged in
users may not terminate as well.
ping(8), setservicetag(8), shownetwork(8),
showntp(8), showpacketfilters(8),
showservicetag(8), traceroute(8)
When the SSCP IP address of an
unmounted SPARC M10-4S chassis is set
up using the setsscp(8) command, the
showsscp(8) command displays the "Not
installed" message and thus, the set IP
address cannot be confirmed. Therefore,
before adding SPARC M10-4S chassis or
cross-bar boxes with the addfru(8)
command, SSCP IP address of the added
chassis cannot be confirmed with the
showsscp(8) command.
When the lockout feature of user
accounts is enabled with the
setloginlockout(8) command, if three
logins to the XSCF Web are performed
with the same user account, further
logins are disabled for the duration of the
configured lockout time.
If server certificate is imported with the
"setldap -c" command, an error is
produced and importing fails.
Configuration of SNMP fails when it is
done from the [SNMP] or the [SNMP
Security] menu of XSCF Web.
Workaround
There is no effective workaround.
[How to restore]
Perform AC OFF/ON.
There is no effective workaround.
Disable the lockout feature of user
accounts.
There is no effective workaround when
the setldap(8) command is used. Use the
encryption feature of LDAP (LDAP over
SSL) with the setldapssl(8) command.
Do not configure SNMP from XSCF Web.
Use the following XSCF shell
commands to configure SNMP.
- setsnmp(8)
- setsnmpusm(8)
- setsnmpvacm(8)
Chapter 3 Information on Software 99