Operating The Parameter Settings Screen - Mitsubishi Electric Q81BD-J61BT11 User Manual

8 OPERATING THE UTILITY SOFTWARE

8.2.5 Operating the Parameter Settings screen

1)
2)
3)
4)
5)
12)
Item
1) Use board setting
2) Channel No.
3) Sta. No./Type
4) Transmission rate
5) Mode
6) Expanded cyclic
7) Occupied Sta.
8) Input for Err. Sta.
9) Other settings button
10) Default button
11) Check button
12) Station information settings
13) Clear button
8 - 10
Various CC-Link Ver.2 board parameters are set on this screen.
(1) Parameter Settings screen
Select all channel No. of the CC-Link Ver.2 boards mounted on the PC.
Select the CC-Link Ver.2 board for which parameters are to be set.
Set the station No. and station type.
Set the transmission rate.
Set the operation mode.
Make the expanded cyclic setting of the CC-Link Ver.2 board. This setting is allowed
when "Sta. Type" is "Local station" and the mode is set to other than "Remote net
Ver.1 mode".
Set the occupied stations count for the CC-Link Ver.2 board (For local station only).
Set how to handle input data in the event of a data link error.
Displays the Other settings screen.
Sets default values to the parameters. (Refer to table 6.1 in Section 6.1)
Checks the currently set parameters for any errors.
Set the total number of connected modules (All connect count) and station
information of each module.
Clears the parameters within the "Station information settings" area to the default
values.
8) 7)
Description
6)
MELSEC
9)
10)
11)
13)
8 - 10