Mitsubishi Electric Q81BD-J61BT11 User Manual page 187

12 COMMUNICATION BETWEEN THE MASTER STATION AND LOCAL
STATIONS
<Parameter settings screen>
1)
2)
3)
4)
15)
16)
Setting item
1) Channel No.
2) Sta. No./Type
3) Transmission rate
4) Mode
5) Expanded cyclic
Operational
6) Occupied Sta.
settings
7) Input for Err. Sta.
8) Retry count
9) Automatic reconnection
station count
10) Standby master station No.
11) Delay information setting
Other settings
12) Driver WDT Monitoring Time
13) Block data assurance per
station
14) Link refresh cycle
Station information
15) All connect count
settings
Sta. No. Station type
16) 1
Intelligent device station
2
3
1: For the local station, select an intelligent device station.
12 - 3
(2) Parameter settings
The following shows the master station's parameter settings by the CC-Link
Ver.2 Utility.
(a) Parameter settings
The following shows the parameter setting values. The parameter setting
check list and the station information setting check list in Appendix can be
used for the setting.
Table 12.1 Parameter Setting Check List
Table 12.2 Station Information Setting Check List
Expanded Occupied
cyclic
Occupies
1
single
4 stations
8)
5)
9)
6)
10)
7)
11)
12)
13)
14)
Setting range/Item
Channel No. 81 / Channel No.82
Channel No. 83 / Channel No.84
No.0 Master station / Local station / Standby master station
156kbps / 625kbps / 2.5Mbps / 5Mbps / 10Mbps
Remote net [Ver.1 mode] / Remote net [Ver.2 mode]
Remote net [Additional mode] / Off line
single / double / quadruple / octuple
Occupies 1 station / Occupies 2 stations
Occupies 3 stations / Occupies 4 stations
0
No setting /
Disable / Enable
No setting /
Remote Reserve/invalid
Sta. station points station select
128 points
<Other settings screen>
Hold / Clear
3 Times
1 Modules
No.0
50 micro sec
8 ms
ms
1 Modules
Intelligent buffer select (word)
Send Receive
No setting 64 64
MELSEC
Automatic
128
12 - 3