Mitsubishi Electric Q81BD-J61BT11 User Manual page 151

8 OPERATING THE UTILITY SOFTWARE
Item
1) Retry count
2) Automatic reconnection station
count
3) Standby master station No.
4) Delay information setting
5) Driver WDT monitoring time
6) Block data assurance per station
7) Link refresh cycle
8) Set button
9) Cancel button
10) Default button
1: The link refresh cycle can be set only when block data assurance per station setting is enabled.
8 - 11
(2) Other settings screen
1)
2)
3)
4)
5)
6)
7)
Set the retry count for the case of a communication error (when a transient
transmission error occurs).
Set the number of modules that can be automatically returned in one link scan.
Set the station No. of the standby master station.
Set 0 to "Delay information setting".
Select "Use driver WDT function" to enable the function.
Set the driver WDT monitoring time.
(1 to 32767)
Select "Assure block data" to enable this function.
Set the link refresh cycle. (1 to 1000)
Saves the settings and closes the Other settings screen.
Closes the Other settings screen without saving the settings.
Set default values as parameters in the Other settings.
(Refer to Table 6.1 in Section 6.1.)
POINT
For details of the parameter settings, refer to Chapter 6.
8)
9)
10)
Description
1
MELSEC
8 - 11