Parameter Settings - Mitsubishi Electric Q81BD-J61BT11 User Manual

10 COMMUNICATION BETWEEN THE MASTER STATION AND REMOTE
I/O STATIONS

10.2.2 Parameter settings

<Parameter settings screen>
1)
2)
3)
4)
15)
16)
17)
Setting item
1) Channel No.
2) Sta. No./Type
3) Transmission rate
4) Mode
5) Expanded cyclic
Operational
6) Occupied Sta.
settings
7) Input for Err. Sta.
8) Retry count
9) Automatic reconnection
station count
10) Standby master station No.
11) Delay information setting
Other settings
12) Driver WDT Monitoring Time
13) Block data assurance per
station
14) Link refresh cycle
Station information
15) All connect count
settings
Sta. No. Station type
16) 1 Remote I/O station
17) 2 Remote I/O station
3
10 - 3
The following shows the master station's parameter settings by the CC-Link Ver.2 Utility.
(1) Parameter settings
The following shows the parameter setting values. The parameter setting check
list and the station information setting check list in Appendix can be used for the
setting.
Table 10.1 Parameter Setting Check List
Table 10.2 Station Information Setting Check List
Expanded Occupied
cyclic Sta.
Occupies
single
1 station
Occupies
single
1 station
8)
5)
9)
6)
10)
7)
11)
12)
13)
14)
Setting range/Item
Channel No. 81 / Channel No.82
Channel No. 83 / Channel No.84
No.0 Master station / Local station / Standby master station
156kbps / 625kbps / 2.5Mbps / 5Mbps / 10Mbps
Remote net [Ver.1 mode] / Remote net [Ver.2 mode]
Remote net [Additional mode] / Off line
single / double / quadruple / octuple
Occupies 1 station / Occupies 2 stations
Occupies 3 stations / Occupies 4 stations
0
No setting /
Disable / Enable
No setting /
Remote Reserve/invalid
station points station select
32 points No setting
32 points No setting
<Other settings screen>
Hold / Clear
3 Times
1 Modules
No.0
50 micro sec
8 ms
ms
2 Modules
Intelligent buffer select (word)
Send Receive
MELSEC
Automatic
10 - 3