APPENDIX
Appendix 6 Replacing the CC-Link Board
Appendix 6.1 Replacing a CC-Link Ver.1 board with a CC-Link Ver.2 board
Activate the "Parameter backup/restoration tool" and back up the
current parameters. (Save to file.).
Removing the CC-Link Ver.1 board currently in use
Uninstall the software package for the CC-Link Ver.1 board.
Turn OFF the personal computer, and remove the CC-Link Ver.1
board.
Mounting a CC-Link Ver.2 board to be used
Install the software package for the CC-Link Ver.2 board.
Install the board to a slot on a personal computer.
Set and check the channel number by the switch.
Test the CC-Link Ver.2 board if there is an error in the hardware of
the installed board.
ctivate "Parameter backup/restore tool", and restore the
A
parameters. (Reading them from files and saving them to the board.)
App - 53
This appendix describes the CC-Link board replacement procedure and precautions.
This section describes how to replace the CC-Link Ver.1 board currently mounted to
the PC with a CC-Link Ver.2 board and precautions to be observed.
Start
↓
Back up the parameters
↓
↓
↓
Restoring parameters
↓
End
• • • Appendix 7.1.2 Backing up parameters
• • • Section 7.2 Installation
• • • Section 5.3.3 Board Installation
• • • Section 5.3.4 Channel No. settings
• • • Section 5.7 Test
• • • Appendix 7.1.3 Restoring parameters
MELSEC
App - 53