Mitsubishi Electric Q81BD-J61BT11 User Manual page 188

12 COMMUNICATION BETWEEN THE MASTER STATION AND LOCAL
STATIONS
12.1.3 Setting the local station
<Parameter settings screen>
1)
2)
3)
4)
Setting item
1) Channel No.
2) Sta. No./Type
3) Transmission rate
4) Mode
5) Expanded cyclic
Operational
6) Occupied Sta.
settings
7) Input for Err. Sta.
Retry count
Automatic reconnection
station count
Standby master station No.
Delay information setting
Other settings
8) Driver WDT Monitoring Time
9) Block data assurance per
station
10) Link refresh cycle
Station information
All connect count
settings
12 - 4
The following shows the local station setting.
(1) Switch setting (channel No. setting)
The channel No. for the CC-Link Ver.2 board is set to 81 as an example in this
section.
For the setting, refer to Section 12.1.2 (1).
(2) Parameter settings
The following shows the local station's parameter settings by the CC-Link Ver.2
Utility.
(a) Parameter settings
The following shows the parameter setting values. The parameter setting
check list and the station information setting check list in Appendix can be
used for the setting.
Table 12.3 Parameter Setting Check List
5)
6)
7)
8)
9)
10)
Setting range/Item
Channel No. 81 / Channel No.82
Channel No. 83 / Channel No.84
No.1 Master station / Local station / Standby master station
156kbps / 625kbps / 2.5Mbps / 5Mbps / 10Mbps
Remote net [Ver.1 mode] / Remote net [Ver.2 mode]
Remote net [Additional mode] / Off line
single / double / quadruple / octuple
Occupies 1 station / Occupies 2 stations
Occupies 3 stations / Occupies 4 stations
0
No setting /
Disable / Enable
No setting /
<Other settings screen>
Hold / Clear
3 Times
1 Modules
No.0
50 micro sec
8 ms
ms
Modules
MELSEC
12 - 4