Mitsubishi Electric Q81BD-J61BT11 User Manual page 242

16 TROUBLESHOOTING
(End)
16 - 8
When the "Found New Hardware Wizard" screen is not displayed automatically after
the board installation, update the driver on the "Device Manager" screen.
If the troubleshooting above does not help, refer to Section 16.7.
POINT
If "Block - Never install unsigned driver software" is selected under [Control Panel] -
[System] - [Hardware] - [Driver Signing], the driver may not be installed.
Select "Ignore - Install the software anyway and don't ask for my approval", or
"Warn - Prompt me each time to choose an action", and install the driver.
1) Open the Windows Device Manager screen. Right-click on
R
"Network Controller" and select "Update Driver Software".
2) Click "Install from a list or specific location (Advanced)".
3) Insert the CD-ROM of the software package to the CD-ROM
drive.
4) Specify the driver software for "Search for driver software in
this location" according to the following information, and click
the Next button.
<For 32-bit version operating system
Specify "\Drivers\x86" of the CD-ROM drive to be used.
(Example: "D:\Drivers\x86")
<For 64-bit version operating system
Check "Include this location in the search" and specify
"\Drivers\x64" of the CD-ROM drive to be used.
(Example: "D:\Drivers\x64")
*1: The operating system can be checked by Windows system
information.
For details, refer to the Microsoft
support.microsoft.com/kb/827218 (As of August 2013)
MELSEC
*1 >
*1 >
Knowledge Base.
R
16 - 8