Mitsubishi Electric Q81BD-J61BT11 User Manual page 156

8 OPERATING THE UTILITY SOFTWARE
Item
1) All stations (1 to 64)
2) Selected station
3) OK button
4) Cancel button
Item
5) Each station information
6) Test result
7) OK button
8 - 16
POINT
(6) The setting of "Standby Master Station No." in the network parameter is
required to execute a line test (hardware) for the standby master station.
(7) When data link has started by the standby master station, a line test (hardware)
cannot be executed.
[Operation Procedure]
After selecting "Line test (Hardware)" in the Test item, click the [Start] button.
The line test screen appears.
Line test screen
1)
2)
3)
Select this when performing the line test on all stations.
Select this when performing the line test on a single station. (Setting range: 1 to 64)
Executes the test.
Cancels the test.
Line test result screen (For "All stations (1-64)" only)
5)
6)
(Display when 4 stations are connected.)
Displays the information of each station.
White: Normal station,
Displays the status of each station.
In the event of an error, the error code is displayed.
Closes the line test result screen.
4)
Description
Description
Red: Error station
MELSEC
7)
8 - 16