Table of Contents
Advertisement
Installing a SODIMM
The SODIMM sockets are located on the top side of the system board; it can be accessed after
removing the chassis cover. The memory module requirements are as follows:
• 260-pin DDR4 SODIMMs
• 2400 or 2133 MHz
• Non-ECC
To install the SO-DIMMs, follow these steps:
1.
Open the system by following the "Removing the Chassis Cover" procedure.
2.
Grasp the module by its edges and align the memory's notch with the socket's key; then
insert the memory into the socket at an angle and push it down until the retaining clips
snap into place.
SODIMM
Notes:
1.
The system supports dual-channel configuration. To enable dual-channel,
populate both SODIMM sockets.
2.
The SODIMM sockets can only accept DDR4 memory modules. Please do not
install other types of memory modules.
Chapter 3 Installing the Devices
Chapter 3
Installing an M.2 Module
The onboard M.2 Type 2280 connector (M Key) is located on the back side of the system board.
It supports SATA 3 modules (6.0 Gb/s) and M.2 PCI Express modules up to PCIe NVMe 3.0 x4.
The system may come
with a pre-installed Intel
riety of capacities.
To install a M.2 module, follow these steps:
1.
Grasp the module by its edges and align the notch of the M.2 module with the key in the
connector.
CPU fan
M.2 SSD connector
13
®
Solid State Drive 600P Series available in a va-
www.dfi.com
Advertisement
Table of Contents
