Table of Contents
Advertisement
Display Interfaces (OPS100-SH and OPS-DB)
Display Interfaces (OPS100-SH)
COM 1
Clear
CMOS
(J23)
1
Battery (J3)
2
1
Buzzer
Intel
CM236/HM170
14
13
2
1
LPC
HRS FX18-60S
HDMI-in Port (OPS100-SH)
The HDMI-in port can be enabled using the BIOS setup utility and be used to connect an
audio/video source, such as a HDMI-compliant output of a PC, and let the signal pass through
the device. The default mode for HDMI-in is disabled. You can configure its mode with the
BIOS Setup Utility.
Chapter 2 Hardware Installation
Chapter 5 Ports and Connectors
HDMI-in
MicroSD
USB 3.0
USB 3.0
Power-on
Intel
Xeon
®
E3-1515M v5
Core™ i5-6440EQ
Core™ i3-6100E
JAE TX25A-80P
SPI Flash BIOS
Chapter 5
Display Interfaces (OPS-DB)
HRS FX18-60P
111
81
1
1
6
SYS Fan (J3)
GPIO (J4)
I2C (J6)
AT/ATX mode
(J17)
Power-on
DPB
DP
Using the Docking Board, the system supports triple display with the following output inter-
faces:
HDMI-out Port (OPS-DB)
The HDMI port, which carries both digital audio and video signals, is used to connect an LCD
monitor or a digital TV that has an HDMI port.
DP Ports (OPS-DB)
The DisplayPort is a digital display interface used to connect a display device. The interface,
developed by VESA and backwards compatible with VGA, DVI and HDMI, delivers higher per-
formance than any other digital interfaces.
BIOS Setting
Configure the display devices in the Advanced menu ("Video Configuration" submenu) of the
BIOS. Refer to Chapter 6 for more information.
Driver Installation
Install the graphics driver. Refer to Chapter 7 for more information.
19
JAE TX24A-80R
140
80
42
41
110
2
1
2
1
A2
PCIE1(PCIe 3.0 x4)
A32
A1
A31
B1
B31
Line_out
B2
B32
(J5)
1
USB PWR
USB PWR
(J16)
3
1
(J15)
1
3
2
+12V Slide Switch
4
COM 1
DP
HDMI-out
1
3
www.dfi.com
Advertisement
Table of Contents
