Installing The Sodimm Module - DFI DT122-BE User Manual

Installing the SODIMM Module

1. There are two SODIMM sockets on the system board.
SODIMM sockets
2. Push the "ejector tabs" which are at the ends of the socket to the side.
Ejector tab
Chapter 3 Installing Devices
Chapter 3
3. Note how the module is keyed to the socket.
4. Seat the module vertically, pressing it down firmly until it is completely seated in the
socket. The ejector tabs at the ends of the socket will automatically snap into the locked
position to hold the module in place.
Ejector tab
12
Notch
Key
www.dfi .com