Table of Contents
Advertisement
Removing the Chassis Cover
Please observe the following guidelines before opening the chassis cover:
1.
Make sure the system and all other peripherals connected to it have been powered off.
2.
Disconnect all power cords and cables.
3.
The mounting screw on the rear side of the system compartment is used to secure the cover
to the chassis. Remove this screw and put it in a safe place for later use.
4.
Use the key (push it down slightly and turn it counterclockwise) to unlock the system com-
partment cover.
5.
Slide the cover backward to open the chassis cover.
Compartment lock
Mounting screw
Chapter 3 Installing Devices
Chapter 3
Installing a SODIMM
The system supports two DDR4 SODIMM sockets.
DDR4_1 Socket
Retention Notch
DDR4_2 Socket
(closer to the edge)
Notch
Retention Clip
Key
To install a memory module:
1.
Grasp the memory module by its edges and align the module's notch with the socket's notch.
4 5 °
Step 1
2. 3. Insert the memory into the socket at an angle, and then push it down until you feel a click.
Step 2
Notes:
1.
The system supports dual-channel configuration with the AMD
processor. To enable dual channel, populate both SODIMM sockets.
Step 3
2.
The SODIMM sockets can only accept DDR4 (3200MHz) memory modules.
Please do not install other types of memory modules.
12
Retention Notch
Notch
Retention Clip
Key
Retention Notch
DDR4 SO-DIMM
Notch
DDR4 SO-DIMM
Retention Clip
Key
Socket Top View
Socket Top View
4 5 °
Step 1
4 5 °
Step 1
Step 2
Step 2
Step 3
Step 3
®
DDR4 SO-DIMM
Socket Top View
GX-217GI
Advertisement
Table of Contents
