Removing The Chassis Cover - DFI OPS100-SH User Manual

Installing the OPS100-SH into the OPS-DB
The OPS+ Module has an accompanying Docking Board and allows it to serve as a standalone
computing system. The plug and unplug mechanism between the OPS+ Module and the
Docking Board utilizes the combo connector at the back of the module. Please use the
following steps to install the OPS+ Module into the Docking Board:
1. Align the OPS+ Module with the slot of the Docking Board and slide the module into the
slot. Note that the venting holes should face upward to allow ambient airflow.
2. Secure the module by tightening the thumbscrews on the front panel.
Thumbscrew
3. Connect the included AC power adapter. Turn on the system by pressing the power switch.
Chapter 3 Installing the Devices
Chapter 3
Thumbscrew
Power switch

Removing the Chassis Cover

1. Observe the precautions at the beginning of this chapter before proceeding with the
procedure. Make sure that all power cords and cables have been disconnected.
2. The 2 mounting screws on the sides and top cover of the system chassis, and the 3 screws
that affix the front panel to the chassis should all be removed to open the system. Put these
screws in a safe place for later use.
Chassis screw
Chassis screw
Chassis screw
3. Lift the cover up to open the system.
12
www.dfi.com