Table of Contents
Advertisement
50
SYS_FAN
O
System Fan: This signal shall be used to control the display panel system
fan.
Recommended pull up +3.3V on docking board side and routed to the
system fan control.
High: System Fan OFF
Low: System Fan ON
Note: This signal shall be triggered ON by the thermal management
system (EC) in the pluggable module only when needed.
Use case: In a situation where the display panel is in standby mode and
the Pluggable Module is still operating (e.g., remote maintenance etc),
the system fan solution may still be needed and since display panel is
in standby mode there is no way to control the system fan. This pin
therefore serves as an option to trigger the system fan to operate when
necessary.
Reserved
41, 42, 43, 44,
RSVD
-
These pins are RESERVED for future expansion and shall be left as No
45, 46, 47, 48,
Connect(NC)
49
Chapter 2 Hardware Installation
Chapter 5 Ports and Connectors
Chapter 5
30
www.dfi.com
Advertisement
Table of Contents
