Table of Contents
Advertisement
ACPI Settings
This section configures system ACPI parameters.
Wake on LAN
Enable or disable WOL (wake-on-LAN) to wake the system through the Ether-
net adapter.
State After G3
This field is to specify which state the system should be in when power is re-
applied after a power failure (G3, the mechanical-off, state).
Always On The system is powered on.
Always Off The system is powered off.
BGRT Logo
Enable or disable the display of an operating system logo or image during boot
using the BGRT (Boot Graphics Resource Table) mechanism.
Wake on RTC
Automatically power the system on at a particular time every day from the
Real-time clock battery. Specify the wake up time of the day below: <hour>,
<minute>, <second>.
Chapter 6 BIOS Setup
Chapter 6
CPU Configuration
This section configures the CPU.
Intel
SpeedStep™
®
Enable or disable the Enhanced Intel SpeedStep
balance between system's power consumption and performance. After it is enabled in
the BIOS, you can take advantage of its offering by setting power schemes from the
operating system's power options.
Turbo Mode
Enable or disable processor turbo mode, which allows the processor core to automati-
cally run faster than the base frequency by taking advantage of thermal and power
headroom. Note this option is not available on the Core™ i3 processor.
CPU C States
Enable or disable CPU Power Management. It allows the CPU to go to C states when it's
not 100% utilized.
Hyper-Threading
Enable Intel
Hyper-Threading Technology (HT) on the processor to improve per-
®
formance of operating systems and software that are optimized for hyper-threading
technology. Please check the software specifications to determine if enabling HT can be
advantageous to the overall system performance.
35
Technology, which helps optimize the
®
www.dfi.com
Advertisement
Table of Contents
