Advertisement
Installing the SO-DIMM Module
Before installing the memory module, please read and follow the safety cautions below.
1.Make sure the PC and all other peripheral devices connected to it has been powered down.
2.Disconnect all power cords and cables.
3.Locate the SO-DIMM socket on the system board.
4.Make sure the notch on memory card is aligned to the key on the socket.
Step 1:
Remove the 4 screws of the heat shield and put them in a safe place for later use.
Remove the heat shield and the SO-DIMM socket is readily accessible.
Step 2:
Insert the memory card into the slot while making sure 1) the notch and the key are aligned,
and 2) the non-connector end rises approximately 45 degrees horizontally. Press the card firmly
into the socket while applying and maintaining even pressure on both ends.
4 5 °
Step 2
Retention Notch
Notch
Retention Clip
Key
DDR3 SO-DIMM
Socket Top View
5
Advertisement
