Table of Contents
Advertisement
Debug Configuration
This section configures the debug function.
Dynamic EFI Debug
Enable or disable output of the log messages for debugging through a serial port.
If you select to enable this function, please set a serial port for this purpose with the
following parameters:
EFI debug print level
Enter or choose the desired print level for displaying different type of log messages. The
options are as follows:
0x00000001: Display messages of system initialization
0x00000002: Display warning messages
0x00000004: Display messages of Load events
0x00000008: Display messages of EFI File system
0x00000040: Display informational debug messages
0x80000000: Display Error messages
0x8000004F: Display all types of messages shown above (This is the default.)
EFI Debug serial port
Enter or choose the serial port number for message output. The options are COM1 (0x3F8)/
COM2 (0x2F8). The default is 0x3F8.
EFI Debug baud rate
Enter or choose the baud rate for serial communication. The default is 115200.
Chapter 6 BIOS Setup
Chapter 6
Device Manager
This Device Manager menu is used to configure UEFI network settings when the "Net-
work Stack" is enabled in the "Dual" or "UEFI" boot mode. Refer to the "Boot" section in
this chapter. To access this menu, go to "Advanced">"Device Manager". The screen will
warn you that you are going to exit the BIOS setup utility.
41
www.dfi.com
Advertisement
Table of Contents
