Getting To Know The Ops100-Sh - DFI OPS100-SH User Manual

Getting to Know the OPS100-SH

Front View
Antenna Hole
HDD LED
HDMI-in
(1)
Antenna Hole USB 3.0
Wireless LED
Power Button
Reset Button
microSD Card
Power Button with LED (Green)
Press this button to power on or power off the system.
USB 3.0 Ports
These ports connect USB 3.0 or USB 2.0/1.1 devices.
HDMI-in Port
This port can be used to connect an HDMI source (e.g. an HDMI port of a computer) and let
the signal pass through to another output display.
Reset Button
Press this button to reset the system without turning on or off the power.
COM Port
This port connects serial devices.
LAN Port
This port connects the system to a local area network (LAN).
Microphone/Line-out Ports
This port connects audio devices such as microphones and speakers.
microSD Card Slot
This port connects a microSD card that complies with SD specification v1.0/v1.1/v2.0 SDHC.
Wireless LED
(2)
The wireless LED indicates the wireless connection status. The LED behavior depends on the
wireless module used.
HDD LED (Green)
This LED indicates the status of the disk drive.
HDD State Disk access activity
LED Behavior Blink
Chapter 1 Introduction
Chapter 1
(1)
COM
LAN
(2)
Mic-in
Line-out
HDD present or HDD not present
Off
Rear View
HRS FX18
HRS FX18/JAE TX25A
The OPS+ Module enables the integration of a pluggable module and a display panel
by employing a defined interconnect based on the JAE and HRS combo plug and their
receptacle connectors.
For detailed pin assignments and connector specifications, refer to Chapter 4 and 5.
Notes:
1. The OPS+ Module is equipped with a Wi-Fi module to provide Wi-Fi connectivity.
Please install antennas to these SMA connectors.
2. There may not be indicator light depending on the installed Wi-Fi module; for
example, the LED will not be lit for Intel
8
JAE TX25A
®
Dual Band Wireless-AC 8260.
www.dfi.com