Step
Display after Operation
5
6
7
8
9
Turn ON the SERVOPACK power supply again after executing advanced autotuning by reference.
Keys
Turn ON the Servo ON (/S-ON) signal.
Input a reference from the host controller
and then press the
start the adjustment.
"ADJ" will flash during adjustment on the
status display.
Note: Adjustment cannot be performed
during "BB" is shown on the status
display.
When the adjustment has been completed
normally, "END" will flash for approxi-
mately two seconds and "ADJ" will be dis-
played.
Press the
will be saved in the SERVOPACK.
"DONE" will flash for approximately two
seconds, and "RUN" will be displayed.
Note: Press the
values. The display returns to the
main menu of the utility function
mode.
3.2 Operations
(cont'd)
Operation
or
Key to
Key. The adjusted values
Key to not save the
9 3
3-69