YASKAWA JUSP-OP05A-1-E User Manual page 10

Wiring
• Be sure to wire correctly and securely.
Failure to observe this caution may result in motor overrun, injury, or malfunction.
• Do not connect a commercial power supply to the U, V, or W terminals for the ser-
vomotor connection.
Failure to observe this caution may result in injury or fire.
• Securely connect the main circuit terminals.
Failure to observe this caution may result in fire.
• Do not bundle or run the main circuit cables together with the I/O signal cables or
the encoder cables in the same duct. Keep the main circuit cables separated from
the I/O signal cables and encoder cables by at least 30 cm.
Placing these cables too close to each other may result in malfunction.
• Use shielded twisted-pair cables or screened unshielded twisted-pair cables for I/
O signal cables and the encoder cables.
• The maximum wiring length is 3 m for I/O signal cables, 50 m for encoder cables
or servomotor main circuit cables, and 10 m for control power supply cables for
the SERVOPACK with a 400-V power supply (+24 V, 0 V).
• Do not touch the power supply terminals while the CHARGE lamp is ON after
turning power OFF because high voltage may still remain in the SERVOPACK.
Make sure the charge indicator is OFF first before starting to do wiring or inspections.
• Be sure to observe the following precautions when wiring the SERVOPACK main
circuit terminal blocks.
• Do not turn the SERVOPACK power ON until all wiring, including the main circuit
• Remove detachable main circuit terminals from the SERVOPACK prior to wiring.
• Insert only one power line per opening in the main circuit terminals.
• Make sure that no part of the core wire comes into contact with (i.e., short-circuits)
• Install a battery at either the host controller or the SERVOPACK, but not both.
It is dangerous to install batteries at both ends simultaneously, because that sets up a loop
circuit between the batteries.
• Always use the specified power supply voltage.
An incorrect voltage may result in fire or malfunction.
• Make sure that the polarity is correct.
Incorrect polarity may cause ruptures or damage.
• Take appropriate measures to ensure that the input power supply is supplied
within the specified voltage fluctuation range. Be particularly careful in places
where the power supply is unstable.
An incorrect power supply may result in damage to the equipment.
• Install external breakers or other safety devices against short-circuiting in external
wiring.
Failure to observe this caution may result in fire.
• Take appropriate and sufficient countermeasures for each form of potential inter-
ference when installing systems in the following locations.
• Locations subject to static electricity or other forms of noise
• Locations subject to strong electromagnetic fields and magnetic fields
• Locations subject to possible exposure to radioactivity
• Locations close to power supplies
Failure to observe this caution may result in damage to the equipment.
x
terminal blocks, has been completed.
adjacent wires.
CAUTION