Steering Shaft - TGB 525 Service Manual

Steering Shaft

Remove
Remove cotter pins, and loosen right and left
steering tie-rod nuts.
Remove tie-rod.
Remove the cotter pin
remove steering shaft nut and washer.
Bend out the steering shaft holder nut fixed plate.
Loosen 2 bolts, and then remove steering shaft
holder, nut fixed plate, pressed plate and steering
shaft.
Inspection
Check oil rings for wear or damage, and replace it if
necessary.
Measure the holder inner diameter.
Maximum limit: Ø39.5 mm
Installation
Install in reverse order of removal procedures.
Apply with grease onto oil liner and holder.
Torque value:
Steering shaft holder bolt
Steering shaft nut
Steering tie-rod nut
PDF created with pdfFactory Pro trial version
To this chapter contents
15. STEERING / FRONT SUSPENSION
steering shaft, and
below
3.4kgf-m
5.0kgf-m
5.0kgf-m
www.pdffactory.com
Steering shaft nut
Oil rings
Oil rings
Cotter pin
Fixed plate
Oil liners
15-5