Steering Shaft - TGB BLADE 250 Service Manual

To this chapter contents
15. STEERING / FRONT SUSPENSION

Steering Shaft

Remove
Remove cotter pins, and loosen right and left
steering tie-rod nuts.
Remove tie-rod.
Steering shaft nut
Remove the cotter pin steering shaft, and
below
remove steering shaft nut and washer.
Cotter pin
Bend out the steering shaft holder nut fixed plate.
Loosen 2 bolts, and then remove steering shaft
holder, nut fixed plate, pressed plate and steering
shaft.
Inspection
Check oil rings for wear or damage, and replace it if
necessary.
Fixed plate
Measure the holder inner diameter.
Maximum limit: Ø39.5 mm
Oil rings
Installation
Install in reverse order of removal procedures.
Apply with grease onto oil liner and holder.
Torque value:
3.4kgf-m
Steering shaft holder bolt
5.0kgf-m
Steering shaft nut
5.0kgf-m
Steering tie-rod nut
Oil rings
Oil liners
15-5