6: Using Operating Mode - Electro Industries Shark 100S Installation & Operation Manual

7.2.6: Using Operating Mode

Operating mode is the Shark® 100S submeter's default mode, that is, the standard
front panel display. After starting up, the meter automatically scrolls through the
parameter screens, if scrolling is enabled. Each parameter is shown for 7 seconds,
with a 1 second pause between parameters. Scrolling is suspended for 3 minutes after
any button is pressed.
1. Press the Down button to scroll all the parameters in Operating mode. The
currently "Active," i.e., displayed, parameter has the Indicator light next to it, on
the right face of the meter.
2. Press the Right button to view additional readings for that parameter. The table
below shows possible readings for Operating mode. Sheet 2 in Appendix A shows
the Operating mode Navigation map.
NOTE: Readings or groups of readings are skipped if not applicable to the meter type
or hookup, or if they are disabled in the programmable settings.
VOLTS L-N VOLTS_LN
VOLTS L-L VOLTS_LL
AMPS AMPS
W/VAR/PF W_VAR_PF
VA/Hz VA_FREQ
Wh KWH_REC
VARh KVARH_PO
S
VAh KVAH
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
OPERATING MODE PARAMETER READINGS
POSSIBLE READINGS
VOLTS_LN_ VOLTS_LN_
MAX MIN
VOLTS_LL_ VOLTS_LL_
MAX MIN
AMPS_NEU AMPS_MAX
TRAL
W_VAR_PF W_VAR_PF
_MAX_POS _MIN_POS
VA_FREQ_ VA_FREQ_
MAX MIN
KWH_DEL KWH_NET
KVARH_NE KVARH_NE
G T
Doc
7: Using the Submeter
AMPS_MIN
W_VAR_PF
_MIN_NEG
KWH_TOT
KVARH_TO
T
E145721
#
VOLTS_LN_
THD
AMPS_THD
7 - 15