Table of Contents
Advertisement
6.3.3: Detailed Configuration Parameters
Certain parameters must be configured before the Ethernet interface can function on
a network. The following procedure can be locally or remotely configured.
Use a Telnet connection to configure the unit over the network. The Ethernet
interface's configuration is stored in meter memory and is retained without power.
The configuration can be changed at any time. The Ethernet interface performs a
reset after the configuration has been changed and stored.
Establish a Telnet connection to port 9999:
1. From the Windows Start menu, click Run and type 'cmd'.
2. Click the OK button to bring up Windows's Command Prompt window.
3. In the Command Prompt window, type:
telnet 10.0.0.1 9999 and press the Enter key.
NOTE: Be sure to include a space between the IP address and 9999.
Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1985-2001 Microsoft Corp.
C:\Documents and Settings\Administrator>telnet 10.0.0.1 9999
The following parameters appear, for example:
Serial Number 5415404 MAC Address 00:20:4A:54:3C:2C
Software Version V01.2 (000719)
Press Enter to go into Setup Mode
4. Press Enter again, quickly.
5. After entering Setup Mode (confirm by pressing Enter), you can configure the
parameters for the software you are using by entering one of the numbers on the
Change Setup Menu, or you can confirm default values by pressing Enter. Be sure
to store new configurations when you are finished. The Ethernet Interface will then
perform a power reset and the Factory Default Settings will display again (refer to
Section 6.2.1).
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
6: Ethernet Configuration
Doc
E145721
#
6 - 8
Advertisement
Table of Contents
