Table of Contents
Advertisement
6: Ethernet Configuration
6.1: Introduction
The Shark® 100S submeter has an option for a WiFi (Wireless) or RJ45 Ethernet con-
nection. This option allows the submeter to be set up for use in a LAN (Local Area Net-
work), using standard WiFi base stations. Configuration for these connections is easily
accomplished through your PC using Telnet connections. Then you can access the
submeter to perform meter functions directly through any computer on your LAN: the
Shark® 100S meter does not need to be directly connected (wired) to these comput-
ers for it to be accessed.
This chapter outlines the procedures you use to set up the Shark® 100S submeter to
function via its Ethernet configuration.
IMPORTANT! These instructions are for Shark® 100S meters that have a Reset
button, located on the main board. You can easily tell whether or not your meter has
a Reset button: open the front cover of the Shark® 100S meter. The Reset button is
located at the top, right of the main board. Refer to the figure on the next page.
Some earlier versions of the Shark® 100S meter are not equipped with a Reset
button. The instructions for Ethernet configuration are slightly different for these
meters. If your meter does not have a Reset button, please call EIG's Technical
Support department (at 516-334-0870) to obtain configuration instructions for your
meter's Ethernet connection.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
6: Ethernet Configuration
Doc
E145721
#
6 - 1
Advertisement
Table of Contents
