B: Shark® 100S Meter Mobus Map; B.1: Introduction; B.2: Modbus Register Map Sections; B.3: Data Formats - Electro Industries Shark 100S Installation & Operation Manual

B: Shark® 100S Meter Mobus Map

B.1: Introduction

The Modbus Map for the Shark
possible readings of the meter and about the programming of the meter. The Shark
100S can be programmed using the buttons on the face plate of the meter (Chapter
7). The meter can also be programmed using software. For a programming over-
view, see Section 5.2. For further details see the Communicator EXT User Manual.

B.2: Modbus Register Map Sections

®
The Shark 100S Modbus Register Map includes the following sections:
Fixed Data Section, Registers 1- 47, details the Meter's Fixed Information described in
Section 8.2.
Meter Data Section, Registers 1000 - 5003, details the Meter's Readings, including
Primary Readings, Energy Block, Demand Block, Maximum and Minimum Blocks, THD
Block, Phase Angle Block and Status Block. Operating Mode readings are described in
Section 7.2.6.
Commands Section, Registers 20000 - 26011, details the Meter's Resets Block, Pro-
gramming Block, Other Commands Block and Encryption Block.
Programmable Settings Section, Registers 30000 - 30067, details the Meter's Basic
Setups.
Secondary Readings Section, Registers 40001 - 40100, details the Meter's Secondary
Readings Setups.

B.3: Data Formats

ASCII:
SINT16/UINT16:
SINT32/UINT32:
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
B: Shark® 100-S Meter Modbus Map
®
100S Meter gives details and information about the
ASCII characters packed 2 per register in high,
low order and without any termination characters.
16-bit signed/unsigned integer.
32-bit signed/unsigned integer spanning 2
registers. The lower-addressed register is the
high order half.
Doc E145721
#
®
B - 1