Table of Contents
Advertisement
Security.................. none
TX Data rate........ 11 Mbps auto fallback
Power management..... not supported in ad hoc mode
D)efault settings, S)ave, Q)uit without save
Select Command or parameter set (1..6) to change:
6.3: Configure Network Module
These procedures detail how to set up the Shark® 100S meter on the Network
Module.
Only one person at a time can be logged into the network port. This eliminates the
possibility of several people trying to configure the Ethernet interface simultaneously.
6.3.1: Configuration Requirements
• You may want to consult your Network Administrator before performing these
procedures, since some functions may be restricted to the Network Administrator.
• If you have only one Ethernet adapter (network card), the screen displays only that
configuration. You will use this Ethernet adapter to access the Shark® 100S
meter's Network Module. You may have to configure the Ethernet adapter in order
to use it with the Shark® 100S meter's Network Module, using the instructions in
Section 6.4.2.
• If you have multiple Ethernet adapters (network cards) installed on your computer,
you must choose, configure and use the correct one to access the Network Module.
• The Ethernet Adapter must be set up for point-to-point connection in order for it to
connect to the Shark® 100S meter's Network module, as follows:
IP Address should be 10.0.0.2
Subnet Mask should be 255.255.255.0
These settings can be made in the Ethernet Adapter. Follow the procedure in
Section 6.3.2.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
6: Ethernet Configuration
Doc
E145721
#
6 - 4
Advertisement
Table of Contents
