Removing And Replacing A Gpu In The Primary Riser - HPE ProLiant DL360 Maintenance And Service Manual

Removing and replacing a GPU in the primary riser

Removing and replacing a GPU in the primary riser
Procedure Procedure
1. Observe the following warning:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Remove the riser cage.
7. If needed, disconnect the GPU power cable and then remove the GPU from the riser.
If there is no power cable, remove the GPU:
Removing and replacing a GPU in the primary riser 143