Table of Contents
Advertisement
Assembly
The sliding table weighs nearly 200 pounds. It
must be lifted and carefully positioned onto saw
frame during assembly. If you are using a forklift
to lift and place it, you'll need to use lifting slings
around table to prevent scratching the aluminum
surface.
If you are not able to use the described forklift
method, the sliding table can be lifted into place
by four strong people—with one lifting from each
corner.
The only other part of the assembly that requires
additional help is installation of the extension
tables and blade guard arm. It takes approxi-
mately two hours to assemble the saw and make
the required adjustments to prepare the saw for
the test run.
To assemble sliding table saw:
1.
Turn sliding table upside down, as shown in
Figure 16.
Figure 16. Sliding table turned upside down.
Lifting heavy machinery
or parts without proper
assistance or equipment
may result in strains, back
injuries, crushing injuries,
or property damage.
Model G0764Z (Mfd. Since 10/15)
2.
Insert (3) M12-1.75 x 50 T-bolts into T-slot
along bottom of sliding table (see Figure 17),
and space them the same distance apart as
mounting holes in cabinet frame.
T-Bolt
(1 of 3)
Figure 17. T-slot along bottom of table.
3.
Lift sliding table over saw and lower T-bolts
into mounting holes on frame, as shown in
Figure 18.
Note: Make sure cap screw shown in Figure
18 is on outside of cabinet frame and against
mount edge.
T-Bolt
(1 of 3)
Figure 18. Inserting T-bolt into mounting hole on
saw frame.
Cap Screw
-25-
Advertisement
Table of Contents
