Blade Tilt Calibration - Grizzly G0764Z Owner's Manual

Blade Tilt Calibration

The blade tilt stops are calibrated at the factory,
but they can be recalibrated if they change during
the life of the machine. The 0° stop positions the
blade square to the table.
Tools Needed
Hex Wrench 3mm .............................................. 1
Machinist's Square, 90° & 45° ........................... 1
0° Stop
1. DISCONNECT MACHINE FROM POWER!
2. Move blade tilt to 0° and raise main blade as
high as it will go.
3. Open cabinet door and identify the stop nuts
shown in Figure 150.
0° Stop
Nut
Figure 150. Blade tilt stop nuts.
-74-
Qty
45° Stop
Nut
4. Use machinist's square to check if main blade
is square to table (see Figure 151).
Blade
Table
Figure 151. Machinist's square against blade
and table.
a. If main blade is not square to table,
loosen the two set screws on 0° stop
nut, then loosen stop nut away from
leadscrew collar.
b. Adjust main blade tilt angle so that it is
square to table.
c. Thread 0° stop nut against leadscrew col-
lar and retighten set screws.
45° Stop
Use a similar procedure for the 45° stop nut
shown in Figure 150, as previously instructed for
the 0° stop nut.
Tilt Scale Calibration
If necessary, the blade tilt scale on the front of the
saw can be adjusted by using the hex nuts shown
on the tilt scale cable in Figure 152. These are
accessed inside the cabinet.
Tilt Scale
Cable Hex Nuts
Figure 152. Tilt scale cable hex nuts.
Model G0764Z (Mfd. Since 10/15)
90° Square