Grizzly G0764Z Owner's Manual page 62

Crosscutting Full-Size Panels
1.
Install crosscut fence in front mounting loca-
tion shown in Figure 118.
Front Mounting
Location
Figure 118. Crosscut fence mounting locations.
2.
Check to make sure fence is at 0°, and if
necessary, adjust it as described in Squaring
Crosscut Fence to Blade on Page 76.
3.
Adjust distance between crosscut fence and
blade (refer to Page 55 for further details).
4. Set either flip stop to the desired width of cut.
Note: Extend the crosscut fence slide if the
workpiece is more than 73".
5. Load workpiece onto table saw in forward
mounting location shown in Figure 115.
6. Take all necessary safety precautions, then
perform cutting operation.
Crosscutting Smaller Panels
1.
Install crosscut fence in rear mounting loca-
tion shown in Figure 115 and lock it in place.
2. Perform Steps 2 & 3 in Crosscutting Full-
Size Panels.
3.
Set either flip stop to the desired width of cut.
Note: Extend the crosscut fence slide if the
workpiece is more than 73".
-60-
Rear Mounting
Location
4. Load workpiece onto table saw in rear mount-
ing location, shown in Figure 118. If neces-
sary, use edge shoe to secure workpiece to
sliding table.
5.
Take all necessary safety precautions, then
perform cutting operation.
Crosscutting Using Rip Fence as
Cut-Off Gauge
1.
Install crosscut fence in rear position of
crosscut table, as illustrated in Figure 117 on
Page 59.
2. Perform Steps 2 & 3 in Crosscutting Full-
Size Panels.
3.
Set rip fence to desired width of cut.
4.
Slide leading end of rip fence behind front
edge of blade (see Figure 119 for an exam-
ple).
Important: This step is critical to reducing
the risk of blade binding and kickback.
Front Edge
of Blade
Figure 119. Example photo of correct rip fence
position when using it as a cut-off gauge
(blade guard removed for clarity).
5. Load workpiece onto table saw and against
rip fence. The setup should look similar to
Figure 119.
6.
Take all necessary safety precautions, then
perform cutting operation.
Model G0764Z (Mfd. Since 10/15)
Rip Fence
Leading Edge
of Rip Fence