Assembly - Grizzly G0970 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
Place cabinet on its side on flat, protected
1.
surface.
Install (1) ⁄ "-16 hex nut and
2. 3
8
on each of (4) feet and thread hex nut all the
way down.
Place (4) assembled feet into holes in bottom
3.
of cabinet and install (4)
(4) ⁄ " flat washers (as shown in Figure 15).
3
8
Leave hand tight for now.
Figure 15. Rubber foot order of installation.
Turn cabinet upright and level by adjusting
4.
feet as needed, then tighten hex nuts to
secure feet (see Figure 16).
Adjustable
Foot
(1 of 4)
Figure 16. Foot installed.
-18-
⁄ " flat washer
3
8
⁄ "-16 hex nuts and
3
8
Foot
Hex Nut
Flat
Washer
Flat
Washer
Hex Nut
Lift bandsaw assembly onto cabinet and
5.
align mounting holes. Make sure belt opening
faces rear of bandsaw assembly.
Secure bandsaw assembly to cabinet with (4)
6.
M8-1.25 x 35 hex bolts, (4) 8mm flat wash-
ers and (4) M8-1.25 flange nuts, as shown in
Figure 17.
x 4
Figure 17. Bandsaw assembly attached to
cabinet.
Open cabinet maintenance door, then loosen
7.
motor tilt lock handle (see Figure 18).
Lift up on tilt handle to tilt motor as far as it
8.
will go; while holding motor up, tighten lock
handle to hold motor in place (see Figure 18).
Belt
Motor
Pulley
Tilt Handle
Figure 18. Motor tilted and locked in place.
Model G0970 (Mfd. Since 07/23)
Tilt Lock
Handle