Grizzly G0764Z Owner's Manual page 42

3. Connect ground wire, then connect incoming
power wires to bottom terminals shown in
Figure 69.
Incoming Power
Terminals
Figure 69. Terminal locations to connect
incoming power wires and ground wire.
-40-
Make sure incoming ground wire is con-
nected to right-most terminal post in the
power junction box so machine is properly
grounded. An ungrounded or improperly
grounded machine may have an electrified
frame which could cause electrocution
when touched.
4.
5.
Ground
Terminal
Make sure wires have enough slack so they
are not pulled tight or stretched.
Re-install junction box cover, and perform
Test Run in following section to check phase
polarity.
Model G0764Z (Mfd. Since 10/15)