Grizzly G0764Z Owner's Manual page 30

13. Fully tighten cap screws from Step 12.
14. Attach small extension table to cast iron
table using (2) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see Figure 29). Only hand tighten
cap screws for now. They will be fully tight-
ened in a later step.
Figure 29. Underside view of large extension
table attached to cabinet.
15. Place a straightedge across cast-iron table
and large extension table to see if tables are
parallel.
—If entire length of straight edge is parallel
with both tables move on to Step 17.
—If both tables are not parallel with straight
edge, loosen hex nuts on set screws
shown in Figure 30. Adjust set screws
to align top of extension table with top of
cast-iron table, then retighten hex nuts to
secure setting.
Hex Nut
Figure 30. Location of set screws and hex nuts
used to level extension table.
-28-
16. Fully tighten cap screws from Step 15.
17. Attach rip fence scale flush along top edge of
18. The rip fence rail is pre-assembled with
Set Screw
cast iron table and large extension table (see
Figure 31) with (3) M6-1 x 12 button head
cap screws, (4) 6mm flat washers, and (1)
M6-1 hex nut.
Rip Fence
Scale
Figure 31. Rip fence scale attached flush with
top edge of cast-iron table and large extension
table.
four rail studs and accompanying hardware.
Remove (1) hex nut, (1) flat washer, and (1)
lock washer from end of each stud, as shown
in Figure 32.
Rail Studs
Figure 32. Removing rip fence rail hardware to
prepare for installation.
Model G0764Z (Mfd. Since 10/15)
x 2
x 1