Setting Up; Crosscut Fence - Grizzly G0764Z Owner's Manual

Setting Up

Crosscut Fence

Before using the crosscut fence to perform
cutting operations, it must be setup properly.
This includes positioning the crosscut fence on
the crosscut table, adjusting the support bar,
adjusting the crosscut fence distance from the
blade, and positioning the crosscut table along
the sliding table.
Positioning Crosscut Fence
The crosscut fence can be mounted in the front
or rear position (see Figure 97) depending upon
the size of the workpiece and which position will
provide the safest operation. The support bar
is adjusted accordingly for maximum workpiece
support.
Front
Position
Crosscut
Table
Crosscut
Table
Rear
Position
Figure 97. Crosscut fence front and rear table
mounting positions.
Whenever the crosscut fence is moved between
the front and rear positions, you must verify the
fence is square to the blade, and the 0° stop bolts
are properly adjusted before using the fence.
Refer to Squaring Crosscut Fence to Blade on
Page 76 for further details.
-54-
Support
Bar
Support
Bar
The support bar can also be installed in either the
inside or outside positions (see Figure 98).
Crosscut
Fence
Crosscut
Table
Crosscut
Table
Outside
Position
Figure 98. Inside and outside support bar
positions.
To position crosscut fence:
1.
DISCONNECT MACHINE FROM POWER!
2.
Unthread and remove knob bolts shown in
Figure 99.
Knob Bolts
Figure 99. Locations of knob bolts securing
crosscut fence.
Model G0764Z (Mfd. Since 10/15)
Inside
Position