Grizzly G0764Z Owner's Manual page 60

Rip Cutting with Rip Fence
1.
Move crosscut table and fence to front of slid-
ing table, and lock them in place with cross-
cut table lock lever (see Figure 110).
Figure 110. Location of crosscut table lock lever.
2. Lock sliding table in place with table lock
lever (see Figure 111).
Figure 111. Location of sliding table lock lever.
3. Loosen slide lock lever shown in Figure 112.
Figure 112. Location of slide lock lever.
4. Place fence in vertical position (see Figure
113) for thicker workpieces, or in horizontal
position for thinner workpieces and for angled
cuts where blade is tilted over the fence.
-58-
Crosscut
Table Lock
Lever
5.
Sliding Table
Lock Lever
6.
Slide Lock
7.
Lever
8.
9.
10. Take all necessary safety precautions, then
Vertical
Horizontal
Figure 113. Rip fence positions.
Position leading edge of rip fence so it
extends across extension wing, as shown in
Figure 114, then retighten lock lever.
Micro-Adjust
Rip Fence
Lock Knob
Figure 114. Proper position of rip fence.
Lift rip fence lock lever (see Figure 114) and
adjust fence to approximate width of cut.
Tighten micro-adjust lock knob (see Figure
114), then turn micro-adjust knob to fine tune
width of cut.
Push rip fence lock lever down to secure
fence assembly in position.
Load workpiece onto table saw. The setup
should look similar to Figure 108 on Page 57.
perform cutting operation.
Model G0764Z (Mfd. Since 10/15)
Micro-Adjust
Knob
Rip Fence
Lock Lever