Table of Contents
Advertisement
9.
Slide M12-1.75 T-nut of push handle assem-
bly into T-slot at front end of sliding table, as
shown in Figure 25. It may be necessary to
loosen T-nut first.
Note: Make sure 12mm flat washer and
12mm copper washer are positioned in front
of T-slot, as shown in Figure 25.
Washers
Push Handle
Figure 25. Push handle attached to sliding table.
10. Attach the cabinet door by sliding hinge
sleeves over pins of already attached hinge
(see Figure 26).
Hinge Sleeves
& Pins
Figure 26. Cabinet door attached on hinges.
Model G0764Z (Mfd. Since 10/15)
T-nut
11. Attach large extension table to cast iron table
using (3) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see Figure 27). Only hand tighten
cap screws for now. They will be fully tight-
ened in a later step.
Figure 27. Underside view of large extension
table attached to cabinet.
12. Place a straightedge across cast-iron table
and large extension table to see if tables are
parallel.
—If entire length of straight edge is parallel
with both tables move on to Step 14.
—If both tables are not parallel with straight
edge, loosen hex nuts on set screws
shown in Figure 28. Adjust set screws
to align top of extension table with top of
cast-iron table, then retighten hex nuts to
secure setting.
Hex Nut
Figure 28. Location of set screws and hex nuts
used to level extension table.
Set Screw
-27-
Advertisement
Table of Contents
