Grizzly G0764Z Owner's Manual page 35

41. In middle of crosscut fence:
a. Insert M8-1.25 x 35 T-bolt into T-slot (see
Figure 47).
Long Knob w/ Fender Washer & T-Slot Plate
T-Bolt
Figure 47. Crosscut fence hardware in the
middle.
b. Align T-slot bolt with slot in pre-installed
scale bar (see Figure 47).
Note: Long knob and fender washer will
help secure crosscut fence in later step.
42. On end of crosscut fence farthest from blade:
a. Insert M8-1.25 T-nut into T-slot
b. Attach 90° stop block to T-nut with
M8-1.25 x 35 cap screw and 8mm lock
washer so that it is aligned with stop bolt
(see Figure 48).
Note: Make sure threaded hole in stop
block is on the right of cap screw.
T-Nut, 90° Stop Block,
Cap Screw, & Lock Washer
Stop
Bolt
Figure 48. 90° stop block installed.
Model G0764Z (Mfd. Since 10/15)
Scale
Bar
Stop Block
Knob Bolt
43. Without moving previously installed hard-
ware, flip crosscut fence over and insert pivot
bolt and T-slot bolt into appropriate hole/slot.
44. Secure crosscut fence to crosscut table by:
a. From underneath left side of crosscut
fence, threading M8-1.25 long knob with
8mm fender washer onto pivot bolt.
b. From underneath middle of crosscut
fence, positioning M8-1.25 T-slot plate
in scale bar slot, then threading M8-1.25
long knob with 8mm fender washer onto
previously installed T-slot bolt.
c. On the right side of crosscut fence, mak-
ing sure 90° stop block is against stop
bolt, then securing fence by threading
M8-1.25 x 50 knob bolt into threaded hole
on stop block.
45. Slide crosscut fence extension out, as shown
in Figure 49.
46. Attach flip stops onto long side of crosscut
fence by sliding T-nuts into T-slots on fence
and tightening the knob bolts (see Figure 49).
Fence Extension
Flip Stop T-Nut
Figure 49. Flip stop attached to crosscut fence.
-33-