Grizzly G0764Z Owner's Manual page 36

47. From underneath right end of crosscut fence,
insert M8-1.25 T-nut into crosscut fence
T-slot, then thread M8-1.25 x 25 knob bolt
with nylon tip through T-nut and into place-
ment hole (see Figure 50). This secures
crosscut fence extension in place.
Knob
Bolt w/
Nylon Tip
Figure 50. Knob bolt and placement hole
(viewed from underneath crosscut fence).
48. Thread (1) M12-1.75 x 70 arm-leveling bolt
with M12-1.75 jam nut into bracket con-
nected to rear of machine body, as shown in
Figure 51.
Arm-Leveling Bolt
M12-1.75 Jam Nut
Arm-
Support
Studs
Figure 51. Arm-support studs installed in body
and arm-leveling bolt installed in bracket.
-34-
Placement Hole
Bracket
49. Remove hex nuts from pre-installed arm-
support studs (see Figure 51), and install
support-arm base onto arm-support studs, as
shown in Figure 52.
Arm-Support Base
Arm-Support Studs
Figure 52. Installing arm-support base.
50. Adjust arm-leveling bolt until arm support
base is parallel with floor (see Figure 53 on
Page 35).
Tip: Check this position by using a tape to
measure the distance between each end of
the arm-support base and the floor.
Note: This parallel position helps ensure the
blade guard is parallel with the table once it is
installed. For now, this positioning should be
very close. It will be checked, and if neces-
sary, fine-tuned in a later step.
Model G0764Z (Mfd. Since 10/15)