Grizzly G0764Z Owner's Manual page 57

3. Lift fence up and loosen pivot bolt (see
Figure 100).
Pivot Bolt &
Rear Hole
Front Hole
Figure 100. Crosscut fence pivot bolt and nut.
4.
Re-insert pivot bolt into front hole or rear
hole, and re-insert angle scale bolt into angle
scale slot.
5.
Rotate fence so stop block is against 0° stop
bolt (see Figure 101).
Figure 101. Stop block against 0° stop bolt.
6. Loosen support bar knob bolts shown in
Figure 102, slide support bar into position
required for operation, then tighten knob
bolts.
Knob Bolts
Figure 102. Locations of knob bolts for adjusting
support bar position.
Model G0764Z (Mfd. Since 10/15)
Nut
Angle
Scale Bolt
0° Stop Bolt
& Block
Support Bar
Adjusting Crosscut Fence Distance
from Blade
To accurately use the crosscut fence scale and
ensure the end block does not contact the blade,
the distance between the crosscut fence and the
blade must be properly adjusted.
To adjust distance between crosscut fence
and blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Perform "To Position Crosscut Fence" proce-
dure starting on Page 54.
3. Move crosscut table (refer to Positioning
Crosscut Table Along Sliding Table on
Page 56 for instructions) so fence end block
is aligned with center of blade (see Figure
103).
3" Mark
Figure 103. End block aligned with blade.
4. Place precision ruler against a blade tooth,
as shown in Figure 103, then adjust fence so
that 3" mark on fence scale is exactly 3" from
blade tooth.
5. Without disturbing pivot bolt position, lift
fence up (see Figure 100), tighten pivot bolt
nut, then re-insert pivot bolt into hole.
6. Repeat measurement in Step 3.
— If measurement is not exactly 3", repeat
Steps 2–10 until it is.
7.
Re-install knob bolts removed earlier to
secure setting.
End Block
-55-