Table of Contents
Advertisement
4.
Prepare scrap test piece by cutting it to 32"
x 32" square, then number all four sides 1–4
(see Figure 157).
Test
Piece
1
Figure 157. Fence adjustment test piece.
5.
Use crosscut fence to cut
of test piece, then cut side 1 again (make five
cuts total).
6.
Measure test piece diagonally from corner-to-
corner, as shown in Figure 158.
— If both measurements are within
you are finished with this procedure.
— If both measurements are not within
then crosscut fence needs to be adjusted.
Proceed to Step 7.
Test
Piece
1
Figure 158. Diagonals to measure on test piece.
Model G0764Z (Mfd. Since 10/15)
2
3
4
⁄
" off of each side
1
2
⁄
", then
1
16
⁄
1
16
2
3
4
7.
Loosen crosscut fence pivot lock knob to
allow fence to pivot.
8.
Loosen hex nut on the 0° stop bolt shown
in Figure 156 on the previous page, rotate
0° stop bolt to square crosscut fence, then
retighten hex nut.
9.
Move crosscut fence stop block against 0°
stop bolt, then retighten pivot lock knob to
secure fence in place.
10. Repeat Steps 5–6.
",
-77-
Advertisement
Table of Contents
