Assembly - Grizzly G0513 Series Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Secure guide post handwheel on handwheel
shaft flat with set screw (see Figure 20).
Figure 20. Guide post handwheel installed.
2. Thread M8-1.25 hex nut halfway onto M8-1.25
x 90 positive stop bolt (see Figure 21).
3. Thread positive stop bolt into threaded hole
on bandsaw body (see Figure 21).
Figure 21. Positive stop bolt installed.
-22-
Guide Post
Handwheel
Positive
Stop Bolt
4. Loosen blade tension by rotating quick-
release tension lever clockwise, as shown in
Figure 22.
Loosen
Figure 22. Quick-release tension lever.
5.
Adjust upper and lower blade guides away
from blade. Refer to Adjusting Blade Guides
beginning on Page 35 for more details.
All saw blades are danger-
ous and may cause per-
sonal injury. To reduce the
risk of being injured, wear
leather gloves when han-
dling saw blades.
6. Remove the saw blade (refer to Changing
Blade on Page 51 for detailed instructions).
7. With the help of another person, lift the table
onto the trunnions.
G0513 Series Bandsaws (Mfd. Since 08/22)
Tighten