Assembly - Grizzly G1023RL Series Owner's Manual

Assembly

Assembly steps are the same for all models
except where noted. Assembly consists of install-
ing the left extension wing, ON/OFF switch, motor
cover, dust port, rails, saw blade, table insert,
blade guard, fence scale, and cursor.
Model G1023RL Only: Mount the right cast iron
wing after installing the left wing.
Model G1023RLW/RLWX/RLX/RLX5 Only:
Mount the router table extension (RLW/RLWX) or
extension table (RLX/RLX5) to the table after the
fence rails are installed. Refer to the instructions
on Page 27 for mounting the router guard and a
router.
To assemble your machine:
Remove shipping crate, bolts that secure cab-
1.
inet to shipping pallet, and shipping brackets
from cabinet. Then move cabinet off of pallet.
— If you plan to mount your saw on a
mobile base, we recommend doing so
now. Assemble mobile base as detailed
in instructions that came with your base.
With help of another person, walk cabinet
off of pallet and place it in mobile base. Or,
if you have a forklift, place a lifting strap
around each side of main table, as shown
in Figure 15. (You must use lifting straps,
each with a minimum capacity of 1000
lbs.) Lift cabinet enough to clear mobile
base, then place it in mobile base.
Figure 15. Lifting straps supporting main table.
-22-
2. Remove motor brace shown in Figure 16.
Brace is installed to prevent shipping damage.
Brace
Figure 16. Motor shipping brace.
Inspect left extension wing and main table
3.
mating surfaces for burrs or foreign materials
that may inhibit assembly. Mating edges of
wing and table must be clean, smooth, and
flat. Use a wire brush or file to prepare edges
so wing mounts properly to main table.
4. Remove (3) bolts and washers from end of
main table.
This machine and its
components
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
move heavy items.
5. Have another person hold left extension wing
in place, then mount it to main table with the
(3) bolts and washers removed in Step 4.
6. Use a straightedge as a gauge and adjust
extension wing up/down until it is flush with
main table above each bolt, then completely
tighten all bolts.
Model G1023RL Series (Mfd. Since 02/21)
are very