Grizzly G0764Z Owner's Manual page 33

29. Install and align riving knife (refer to Riving
Knife Alignment beginning on Page 46 for
detailed information).
30. Close blade cover. Center sliding table and
lock in place.
31. Position rip fence
1
32. Slide rip fence stop ring onto end of rail
and tighten set screw to secure it in place
(see Figure 41). When installed correctly,
this ring will prevent rip fence from contacting
blade.
Figure 41. Rip fence stop ring attached to rail.
Model G0764Z (Mfd. Since 10/15)
⁄ " away from main blade.
8
Rip Fence
Stop Ring
w/Set Screw
33. Install rip fence end stop on opposite end of
rip fence rail with (1) M8-1.25 x 15 cap screw
and (1) 8mm lock washer (see Figure 42).
Figure 42. Rip fence end stop attached to rail.
34. Adjust rip fence to main blade and tables as
instructed in Calibrating Rip Fence on Page
79.
35. Thread M12-1.75 x 55 adjustable lock handle
with a 12mm flat washer through hole in short
side of crosscut table and into a M12-1.75
T-nut plate, as shown in Figure 43.
Flat Washer
Lock
Handle
Figure 43. Crosscut lock handle installed on
crosscut table.
Rip Fence
End Stop
T-Nut
Plate
-31-