Assembly - Grizzly G0622 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble the bandsaw:
1. Install head-locking pin (refer to Page 22).
2. With help of an assistant, lift bandsaw onto
a pair of closely spaced sawhorses or other
suitable support (see Figure 6).
3.
Attach legs to bandsaw with (8) M8-1.25 x
25 hex bolts, (8) 8mm flat washers, (8) 8mm
lock washers, and (8) M8-1.25 hex nuts (see
Figure 6).
Note: At this time, tighten with a 14mm
wrench or socket just enough to secure the
parts. Final tightening will take place when
the stand is fully assembled.
Figure 6. Attaching legs to bandsaw.
4.
Attach short brace to legs with (4) M8-1.25 x
16 carriage bolts, (4) 8mm flat washers, (4)
8mm lock washers, and (4) M8-1.25 hex nuts
(see Figure 7).
Model G0622 (Mfd. Since 09/17)
Figure 7. Short braces attached to legs.
5. Remove bandsaw from sawhorses and attach
long braces to legs with (4) M8-1.25 x 16 car-
riage bolts, (4) 8mm flat washers, (4) 8mm
lock washers, and (4) M8-1.25 hex nuts (see
Figure 8).
Figure 8. Long braces attached to legs.
6. Attach wheel-mounting bracket to bottom of
two legs with (2) M6-1 x 12 hex bolts, (4)
6mm flat washers, (2) 6mm lock washers,
and (2) M6-1 hex nuts, as shown in Figure 9.
Wheel-
Mounting
Bracket
Figure 9. Wheel-mounting bracket attached to
legs.
Short
Braces
Long
Brace
-15-