Grizzly G0764Z Owner's Manual page 34

14" sliding table saw
Table of Contents

Advertisement

36. With assistance from other people, place
crosscut table on swing arm pivot rod and
slide T-nut plate into sliding table T-slot, as
shown in Figure 44.
Crosscut Table
T-Slot
Figure 44. Attaching crosscut table to machine
frame.
37. Slide (2) M8-1.25 T-nuts into crosscut table
brace T-slots, and align them with center
holes in crosscut table (see Figure 45).
Crosscut Table Brace
Figure 45. Example of table brace attached to
crosscut table.
-32-
Swing Arm
Pivot Rod
T-Nut Plate
38. Secure table brace by threading (2) M8-1.25
x 50 knob bolts with (2) 8mm flat washers into
brace T-nuts (see Figure 45).
39. Turn crosscut fence onto its side.
40. On crosscut fence end nearest blade:
a. Insert (1) M8-1.25 T-nut into T-slot, then
loosely thread M8-1.25 pivot bolt with
8mm fiber flat washer into T-nut (see
Figure 46).
End Cap
T-Nut, Pivot Bolt,
& Fiber Flat Washer
Figure 46. Crosscut fence hardware near to
blade.
b. Position crosscut fence so edge cap (see
Figure 46) is close to but not touching
main blade.
c. Align the pivot bolt with pivot hole (see
Figure 46), then fully tighten pivot bolt.
Note: Long knob and fender washer will
help secure crosscut fence in later step.
Model G0764Z (Mfd. Since 10/15)
Long Knob
& Fender Washer
Pivot
Hole

Advertisement

Table of Contents
loading

Table of Contents