Grizzly G0764Z Owner's Manual page 55

Aligning Scoring Blade
1.
DISCONNECT MACHINE FROM POWER!
2.
Adjust main blade tilt to 0° and raise blade all
the way up.
3. Raise blade guard up and move it away from
blade.
4. Align scoring blade body horizontally to main
blade body by:
a. Rotating knurled lock collar shown in
Figure 96 counterclockwise to loosen it.
Height
Adjustment Knob
Figure 96. Scoring blade adjustment controls.
b. Positioning straightedge against the
flat of main blade body (not teeth) and
extending it over scoring blade body.
c. Rotating horizontal adjustment knob to
align bodies of blades.
Note: Rotating knob clockwise moves
scoring blade to the left and counter-
clockwise moves it to the right.
d. Tightening lock collar clockwise to secure
setting.
Model G0764Z (Mfd. Since 10/15)
Lock
Collar
Horizontal
Adjustment Knob
5. Align scoring blade kerf to main blade kerf by:
a. Positioning straightedge on one side of
main blade flat on table and against main
blade and scoring blade teeth.
b. Rotating knurled lock collar behind height
adjustment knob (see Figure 96 on pre-
vious page) counterclockwise to loosen
it.
c. Using height adjustment knob to adjust
scoring blade so that the edge of scoring
blade teeth are aligned with main blade
teeth.
Note: Rotating knob clockwise lowers
scoring blade and counterclockwise rais-
es it.
d. Tightening lock collar clockwise to secure
setting.
6. Repeat Step 5 for other side of blades to
verify kerf thickness matches and scoring
blade is aligned with main blade.
7.
Close blade cover, properly reposition blade
guard, and slide table back to center of
machine.
8. Perform a test cut and check for chip-out.
— If there is chip-out, repeat this procedure
until corrected.
-53-