Table of Contents
Advertisement
4.
Install end plate with handle, as shown in
Figure 19, using the screws pre-installed in
this location on the sliding table.
Figure 19. Slide table control end handle.
5.
Position sliding table against parallelism
adjustment bolts at each end (see Figure 20).
Parallelism Adjustment Bolt
(1 of 2)
Sliding Table
Figure 20. Sliding table parallelism adjustment
bolt (1 of 2).
6.
Remove access covers on each side of the
frame to reach the T-bolts on the ends of the
sliding table (Figures 21–22). Reach through
cabinet access hole to reach middle sliding
table T-bolt (Figure 23).
Sliding Table T-Bolt
Figure 21. Sliding table T-bolt access on rear
side at back of saw.
-26-
End Plate
w/Handle
Figure 22. Sliding table T-bolt access on rear
Figure 23. Sliding table middle T-bolt access.
7.
8.
Figure 24. End cap secured on sliding table with
Sliding Table T-bolt
side at front of saw.
Sliding Table T-bolt
Cabinet Access Hole
Put (3) M12-1.75 hex nuts, (3) 12mm lock
washers, and (3) 12mm flat washers on end
of each T-bolt and tighten to secure sliding
table to frame (as shown in Figures 21–23).
Attach end cap (as shown in Figure 24) with
Phillips screws already threaded into those
same holes on the sliding table.
End Cap
Phillips Screws
Phillips screws.
Model G0764Z (Mfd. Since 10/15)
(Middle)
Advertisement
Table of Contents
